CorkSport Mazda 3 2010-2013 Exhaust System Mazda 3, 2.0 Liter Standard and SkyActiv Engine
Buy now pay later,no extra cost!
Payments from $134.55 with
If this product is not in stock please check availability with us first before ordering.
Maximize airflow and increase power with the CorkSport Power Series Single Exit 60mm Exhaust for the 2010-2013 2.0 liter standard and SkyActiv Mazda 3.
Featuring dual resonators, a slip fit compression connection to the aft end of the catalytic converter and a single tailpipe design, the CorkSport Mazda 3 exhaust eliminates the factory tailpipe muffler and features a non-resonated CorkSport dual wall 90mm exhaust tip.
During testing, the CorkSport Mazda 3 Power Series Single Exit Exhaust went from a baseline of 118hp/110lb ft. of torque to a respectable 135hp and 123lb ft. of torque at the wheels when tested with the CorkSport Power Series Short Ram Intake. The 2.0L results are moderate at the bottom end (with around a 4-5hp/tq gain) below 4000rpm with the majority of the power coming on rapidly at around 4500rpm and held steadily to the 7000rpm redline. This really shows how constrained the stock system was for the smaller 2.0L engine.
The CorkSport Advantage:
- Features dual resonators, a slip fit compression connection and single tailpipe design.
- Mandrel bent Stainless Steel T304 construction for corrosion resistance and clean stylish look.
- Optional 60mm racepipe with or without high flow catalytic converter* attaches between the factory header downpipe flange and the front compression fitting of the cat-back portion of the exhaust system
- Distinctive performance sound mild but noticable at cruise and idle and a distinctive growl at wide open throttle and free rev.
- Picks up all of the stock hanger locations.
- Power Series exhaust AND racepipe will not cause a CEL (Check Engine Light).
- Corksport Service and Support: Receive a 2 year warranty, full color installation instructions, all of the needed installation hardware, and knowledgeable telephone installation support.
**Installation of the cat back system requires cutting your factory exhaust system after the second catalyst. The race pipe versions of the exhaust are bolt on with no cutting required. See CorkSport FAQ and Instructions for detailed instructions.
